Sputter 1 (Custom): Difference between revisions
(Created page with "{{tool|{{PAGENAME}} |picture=Sputter1.jpg |type = Vacuum Deposition |super= Adam Abrahamsen |phone=(805)839-3918x213 |location=Bay 3 |email=abrahamsen@ece.ucsb.edu |description …") |
No edit summary |
||
Line 7: | Line 7: | ||
|email=abrahamsen@ece.ucsb.edu |
|email=abrahamsen@ece.ucsb.edu |
||
|description =Three-Target DC/RF Sputtering System |
|description =Three-Target DC/RF Sputtering System |
||
|manufacturer = |
|manufacturer = ? |
||
|materials = |
|materials = |
||
}} |
}} |
Revision as of 15:02, 10 July 2012
|
About
The Three-Target DC/RF Sputtering System, built by Sputtered Films, Inc. is based on the "Research S-Gun" and as such, is capable of high sputtering rates (~ A/min.) for metal, semiconductor and dielectric materials with a minimal substrate bombardment caused by secondary electrons. The deposition chamber is non-loadlocked providing for easy sample loading and target/gun changing. Venting and evacuation are automated with a 500 l/s turbo (capable of pumping O2) achieving an ~ 2 E-7 T ultimate pressure (~ 1E-7 with liquid nitrogen flange pocket) in about 6-8 hours. Substrates are clip mounted onto one of several 6 inch diameter platens which mount into a rotating 4-position planetary "flat-wheel". This flat-wheel is concentric with a rotating 3-blade shutter assembly. Each are then manually positioned over one of three sputtering guns, operating one at a time. Available gases for injection include Ar/N2/O2, the latter allowing for nitride and oxide formation. Flow rates of <100 sccm are controlled with standard mass flow controllers. Gun power supplies include: 2.4 kW DC magnetron driver, 13.56 Mhz RF supply for sample sputter cleaning, and a SparcLE Pulsed DC Unit for reactive sputter deposition. Operation is usually in a constant power mode (200-500 watts) with the resulting optimum V, I (and chamber pressure) dependent on the target material. Present available targets include: Al, Al(0.5% Cu or 4% Cu), Ag, Au, Cr, ITO, Nb, Si, Ti, W, W-Si and Zr-Y.
Detailed Specifications
- 3 target with DC or Pulsed-DC operation
- Low E-7 T ultimate pressure (10 mT typical operating pressure)
- 6" diameter sample holder platen with 4" sample-gun spacing
- Deposition uniformity is ~ 85% over 2 " diameter for SiO2 deposition at 300W