Oven 4 (Thermo-Fisher HeraTherm): Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
{{ |
{{tool2|{{PAGENAME}} |
||
|picture=Oven4.jpg |
|picture=Oven4.jpg |
||
|type = Lithography |
|type = Lithography |
||
| Line 11: | Line 11: | ||
}} |
}} |
||
== |
==About== |
||
This oven is often used for long thermal cures and wafer bonding. It has programmable temperature ramps and hold times, but the ramp rate is only "low/med./high" (not an exact ramp rate). A manual needle valve for nitrogen purge has been installed on the back of the oven. |
This oven is often used for long thermal cures and wafer bonding. It has programmable temperature ramps and hold times, but the ramp rate is only "low/med./high" (not an exact ramp rate). A manual needle valve for nitrogen purge has been installed on the back of the oven. |
||
== |
==Specifications== |
||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
* {{todo|User Manual}} |
|||
| ⚫ | |||
| ⚫ | |||
| ⚫ | |||
* |
|||
{{Instructions}} |
|||
[https://wiki.nanotech.ucsb.edu/w/images/8/8e/Heratherm_instructions.pdf Instructions] |
|||
<br /> |
|||
Latest revision as of 23:25, 13 September 2022
| ||||||||||||||||||||||||||||||||
About
This oven is often used for long thermal cures and wafer bonding. It has programmable temperature ramps and hold times, but the ramp rate is only "low/med./high" (not an exact ramp rate). A manual needle valve for nitrogen purge has been installed on the back of the oven.
Specifications
- Maximum Temperature = 330 C (no active cooling)
- Gases: N2, manually set with needle valve (not programmable)
- Multi-step programmable temperature ramps
- Programmable atmospheric purge (for cooling)
Documentation