Sputter 3 (AJA ATC 2000-F)

Sputter 3 (AJA ATC 2000-F) Tool Type Vacuum Deposition Location Bay 3 Supervisor Tony Bosch Supervisor Phone (805) 893-3486 Supervisor E-Mail bosch@ece.ucsb.edu Description Six-Target DC/RF Magnetron Sputtering System Manufacturer AJA Vacuum Deposition Recipes Sign up for this tool

About

The Six-Target DC/RF Sputtering System, built by AJA International uses planar magnetron sources. The sources are contained in tiltable sputter gun modules that allow for maintaining uniformity control at various sample heights. Cross contamination between sources is minimized by using a chimney configuration with very narrow source shutter gaps. Uniformity better than 2% over 90mm. 2 DC sources and 2 RF sources allow for co-deposition of materials, including dedicated magnetic films Fe, Ni, and Co. Other materials, such as ITO, Si, Al, Zr, etc. can be reactively RF sputtered in an O₂ or N₂ environment to produce metal-oxides or nitrides. The deposition chamber is loadlocked providing for fast substrate transfer and consistent, low base pressure. Venting and evacuation are automated with a 1200 l/s turbo (capable of pumping O₂) achieving an ~ 4.0 E-8 T ultimate pressure. A VAT adaptive pressure control valve is used for process pressure control independent of gas flow. Substrates are clip mounted onto 4 inch carriers. Flow rates are controlled with standard mass flow controllers. Argon is used for the sputter gas, with N₂ and O₂ used for reactive sputtering. Gun power supplies include: 500W DC, 13.56 Mhz 300W RF, and a 50W substrate RF supply for in-situ substrate biasing and pre-cleaning. Samples can be heated to 650°C. The system is recipe driven and computer controlled for reproducible results.

Detailed Specifications

• 6 target with DC or RF operation
• Reactive sputtering with N₂ or O₂ using RF or DC
• Co-deposition of up to four materials: 2 DC and 2 RF
• Magnetic Material Deposition: Fe, Ni, Co
• SiO₂, SiN, ITO, AlN, Al2O3 and other metal-oxide/nitrides possible
• Low E-8T ultimate pressure (3 mT typical operating pressure), load-locked chamber
• 4" diameter sample holder
• Gun Tilt, Sample height and rotation adjustments
• Deposition uniformity is ~ 1-2% over 4 " diameter
• Up to 650°C dep temperature
• RF Biasing of sample during deposition or as a pre-deposition clean
• The Sputter #3 SignupMonkey page lists the currently installed sputter targets.

Documentation

• Operating Procedures

Materials Table

For the materials tables, please visit the Sputter 3
(ATC 2000-F).