Dicing Saw (ADT)

Dicing Saw (ADT) Tool Type Packaging Location Dicing Room: ESB 1147 Supervisor Lee Sawyer Supervisor Phone (805) 893-2123 Supervisor E-Mail lee_sawyer@ucsb.edu Description ADT Dicing Saw Manufacturer Advanced Dicing Technologies Ltd. Model ADT 7100 Sign up for this tool

About

The ADT 7100 Dicing Saw is optimized for multi-angle dicing of thin, tight tolerance products up to 200 mm x 200 mm. It is currently setup for dicing up to 8” diameter wafers. Check the Dicing Saw Recipes page for the blades we currently stock.

An ADT WM-966 tape applicator & Ultron Systems UH104-8 UV lamp system is used to apply UV-release tape for securing die during dicing.

Contact the tool supervisor for blades and dicing frames for your group.

Operating Procedures

• ADT Dicing Saw Standard Operating Procedure
• Setting up the Saw before Cutting - Disregard and refer to SOP above
• Standard Dicing Procedure - Programmed Cut Map
• Standard Dicing Procedure - Single Cuts
• Recovering an Old Recipe

Recipes

• Recipes > Packaging > Dicing Saw Recipes (ADT 7100)

Be sure to also see the recipes for protecting your sample from dicing dust, and mounting/unmounting.