Dead-end pages

Jump to navigation Jump to search

The following pages do not link to other pages in UCSB Nanofab Wiki.

Showing below up to 50 results in range #1 to #50.

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)

  1. ADT 7100 - Initial Setup Before Cutting
  2. ADT 7100 - Recovering an Old Recipe (2019)
  3. ADT UV-Tape Table 1042R
  4. ASML 5500: Choose Marks for Prealignment
  5. ASML 5500: Recovering from a Typo in Reticle ID
  6. ASML Stepper 3: Wafer Handler Reset Procedure
  7. ASML Stepper 3 - Substrates smaller than 100mm/4-inch
  8. AUTOSTEP 200-PIECES 1st litho BL and BR orientation.pptx
  9. Adam Abrahamsen
  10. Autostep 200 Old training manual
  11. Autostep 200 User Accessible Commands
  12. CC-PRIME OnBoarding 2022-08
  13. CDE ResMap Quick-Start instructions
  14. Chemical List - OLD 2018-09-05
  15. Claudia Gutierrez
  16. Comparison of ash rate for different gas mixtures, especially between O2 only vs O2/N2 mixture.
  17. DS-K101-304 Bake Temp. versus Develop Rate
  18. Electronics Presentations
  19. Ellipsometer (Woollam) - Measuring thin metals with oxide pre-measurement
  20. Errors
  21. Filmetrics F10-RT-UVX Operating Procedure
  22. Foong Fatt
  23. GCA 6300 Reboot Procedures
  24. GCA 6300 USer Accessible Commands
  25. GCA 6300 training manual -old instructions
  26. Glossary
  27. Gold surface oxidation (darkening) due to O2/N2 plasma; the need for O2 only recipe.
  28. Goniometer (Rame-Hart A-100) - Operating Procedure
  29. InP Etch Rate and Selectivity (InP/SiO2)
  30. InP Etch Test-in details
  31. InP Etch Test Result in Details
  32. InP Etch test -details
  33. InP etch result in details
  34. Jack Whaley
  35. KLA Tencor P7 - Basic profile instructions
  36. KLA Tencor P7 - Saving Profile Data
  37. Lab Rules OLD 2018
  38. MA6 Backside Alignment - Allowed Mark Locations
  39. Michael Barreraz
  40. Mike Silva
  41. Nanofab-IT - Add Device to Network
  42. Old Training Manual
  43. Old training manual
  44. Olympus LEXT OLS4000 Confocal uScope - Quick Start
  45. Oxford Etcher - Sample Size Effect on Etch Rate
  46. PECVD.docx
  47. PECVD1-(PlasmaTherm 790)
  48. PECVD1-SiN-standard recipe.pdf
  49. PECVD1-SiN standard recipe.pdf
  50. PECVD1 Operating Instructions.pdf

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)

Retrieved from "https://wiki.nanofab.ucsb.edu/wiki/Special:DeadendPages"